GnarlyFPV Primo V110X Frame Kit

Description

The Primo, was designed to take the current 1S and 2S EVEN 3S Brushless whoops guts, and plant them into a frame that pushes the limits of micro FPV. Designed to make the swap as simple and seamless as possible. GnarlyFPV wanted something that could be swapped over in a matter of minutes, with no soldering required. The battery mounts are quick swappable, with 1 M2 screw. Swap from 1S to 2S, to 3S in seconds. Frames are stout, at 2mm's thick. However, as tough as the primo is, it's not indestructible, so replacement frames will be available separately. Each kit will include all hardware needed for a brushless whoop swap. Just add your Brushless whoop guts. Supports 16X16 stacks.
A
vailable in 080X and 110X flavors.
This 110X version does support both 9mm and 8.5mm 4 hole mounting pattern motors.
Weight:
An Insane weight of 10.5 Grams! (Including 2S Mount, and EOS2 Camera)
Included:
Primo 110X Frame
Full set of 65mm Props
Jelly FC Mount
EOS2 Camera Mount
AIO Camera Mount
Canopy
1S EZ swap mount (450mAh GNB -)
1S X2 (Stick) EZ Swap mount (230 mAh - 333 mAh)
2S (RDQ 300mAh stick) EZ swap mount
2S/3S (300mAh-350mAh GNB)EZ swap mount
Hardware
Supports the below models electronics (just add your favorite 4 pattern 110X motor):
Eachine Trashcan
Mobula7
Beta65 pro
Beta65 Pro 2
Beta65 X
Beta75 Pro
Beta75 Pro 2
Snapper 6
Snapper 7
UPDATES and NOTES:
The Primo Canopy
supports
the Runcam Racer Nano, Runcam Nano 2 EOS2, and MOST AIO 25mw cameras, such as the Mobula 7/ SailFlyX AIO cameras. (Adapters for the EOS2 and AIO Camera is included in the kit)
Available separately, are the Runcam Racer nano, and Nano 2 adapters.
If using the older Betafpv double stacks, OR 16x16 stacks, you'll have to raise the canopy higher to allow for clearance. M2 standoffs work perfectly.
If using the older Betafpv double stacks OR 16x16 stacks, you'll have to raise the canopy higher to allow for clearance. M2 standoffs will work perfectly.
NOTE:
Motor wire extensions
available as an add on for betafpv motors, and or motors with shorter leads.
Trashcan VTX adapter sold separately.
Have your stack bound to your radio, before the transplant.
This version is for 110X motors with the 4 hole mounting patterns. Does NOT support three hole mounting pattern motors.
The latest Crazybee F4 Pro V2.1 boards include a new VTX connector. This connector is to large to fit properly on the Primo when laying face down (as was designed to) A solution would be to remove the plug entirely, and direct solder the camera/vtx.